1
00:00:00,560 --> 00:00:06,560
IPV six was developed by the Internet Engineering Task Force IETF.

2
00:00:06,590 --> 00:00:13,280
I'm sure you looked it up to deal with the long anticipated problem of IPv4 address exhaustion.

3
00:00:13,870 --> 00:00:18,310
So IPV six is intended to replace IPV four.

4
00:00:19,470 --> 00:00:28,740
IPv6 became a draft standard in December 1998 and became an Internet standard on the 14th of July 2017.

5
00:00:29,790 --> 00:00:37,860
So instead of 32 bit addressing of IPV four, which provides approximately 4.3 billion addresses, IPV

6
00:00:37,860 --> 00:00:41,310
six uses a 128 bit address.

7
00:00:41,310 --> 00:00:52,020
So that theoretically gives us two to the power of 128 or approximately 3.4 times ten to the 38th addresses.

8
00:00:52,050 --> 00:00:53,040
Big number.

9
00:00:53,710 --> 00:00:56,560
You can check my math later, but stick with me for now.

10
00:00:57,570 --> 00:01:04,680
I mean, the actual number is slightly smaller as multiple ranges are reserved for special use or they're

11
00:01:04,680 --> 00:01:06,930
just completely excluded from use.

12
00:01:07,170 --> 00:01:15,450
But with a rough calculation, the total number of possible IPV six addresses is more than 7.9 times

13
00:01:15,450 --> 00:01:20,460
ten to the power of 28 times as many as IPV four.

14
00:01:21,390 --> 00:01:27,420
The two protocols IPV four and IPV six are not designed to be interoperable.

15
00:01:28,100 --> 00:01:35,690
Complicating the transition to IPv6, however, several IPv6 transition mechanisms have been devised

16
00:01:35,690 --> 00:01:40,880
to permit communication between IPV four and IPV six hosts.

17
00:01:41,710 --> 00:01:49,390
In addition to offering more addresses, IPV six also implements features not present in IPV four.

18
00:01:49,950 --> 00:01:51,330
Simplified header.

19
00:01:52,170 --> 00:01:59,280
IPv6 header has been simplified by moving all unnecessary information and options which are present

20
00:01:59,280 --> 00:02:04,590
in the IPv4 header to the end of the IPv6 header.

21
00:02:04,920 --> 00:02:13,590
The IPv6 header is only twice as big as an IPV four header because that IPV six address is four times

22
00:02:13,590 --> 00:02:14,370
longer.

23
00:02:15,610 --> 00:02:17,230
End to end connectivity.

24
00:02:18,160 --> 00:02:24,610
Every system now has a unique IP address and can traverse through the internet without using Nat or

25
00:02:24,610 --> 00:02:26,380
other translating components.

26
00:02:27,190 --> 00:02:34,660
After IPV six is fully implemented, every host can directly reach other hosts on the internet with

27
00:02:34,690 --> 00:02:41,170
well with some limitations involved, like a firewall organization, policies and stuff like that.

28
00:02:42,800 --> 00:02:44,240
Autoconfiguration.

29
00:02:44,860 --> 00:02:52,150
IPV six supports both stateful and stateless autoconfiguration mode of its host devices.

30
00:02:52,450 --> 00:02:59,110
This way the absence of a Dhcp server does not put a halt on inter-segment communication.

31
00:03:00,100 --> 00:03:01,930
Faster forwarding and routing.

32
00:03:02,800 --> 00:03:08,590
A simplified header puts all unnecessary information at the end of the header like we saw earlier.

33
00:03:08,680 --> 00:03:14,620
The information contained in the first part of the header is adequate for a router to make its routing

34
00:03:14,620 --> 00:03:19,240
decisions, thus making them as quickly as looking at the mandatory header.

35
00:03:20,350 --> 00:03:21,460
IPsec.

36
00:03:22,880 --> 00:03:31,010
Initially it was decided that IPV six must have IPsec making it more secure than IPV four.

37
00:03:31,220 --> 00:03:33,830
This feature has now been made optional.

38
00:03:35,280 --> 00:03:43,620
IPsec Internet Protocol security is a framework of open standards for helping to ensure private, secure

39
00:03:43,620 --> 00:03:46,500
communications over Internet protocol networks.

40
00:03:46,530 --> 00:03:51,030
IP networks through the use of cryptographic security services.

41
00:03:51,610 --> 00:03:58,540
IPsec is an end to end security scheme operating in the network layer, while some other internet security

42
00:03:58,570 --> 00:04:04,360
systems in widespread use, TLS and SSH operate in the upper layers.

43
00:04:04,390 --> 00:04:09,250
IPsec can automatically secure applications at the IP layer.

44
00:04:10,090 --> 00:04:11,560
No broadcast.

45
00:04:12,400 --> 00:04:18,430
Though Ethernet and token ring are considered a broadcast network because they support broadcasting.

46
00:04:18,640 --> 00:04:22,660
IPV six does not have broadcast support anymore.

47
00:04:22,690 --> 00:04:26,650
It uses multicast to communicate with multiple hosts.

48
00:04:27,780 --> 00:04:28,860
Mobility.

49
00:04:29,280 --> 00:04:32,850
IPV six was designed keeping mobility in mind.

50
00:04:33,060 --> 00:04:39,420
This feature enables hosts such as a mobile phone to roam around in different geographical areas and

51
00:04:39,420 --> 00:04:41,910
remain connected with the same IP address.

52
00:04:42,210 --> 00:04:49,770
The mobility feature of IPV six takes advantage of auto IP configuration and extension headers.

53
00:04:51,130 --> 00:04:52,300
Extensibility.

54
00:04:52,940 --> 00:05:00,680
One of the major advantages of the IPv6 header is that it is extensible, adding more information in

55
00:05:00,680 --> 00:05:01,790
the option part.

56
00:05:02,550 --> 00:05:09,270
IPV four provides only 40 bytes for options, whereas options in IPV six can be as much as the size

57
00:05:09,270 --> 00:05:11,280
of the IPV six packet itself.

58
00:05:12,310 --> 00:05:15,070
What is the IPV six packet you ask?

59
00:05:15,100 --> 00:05:16,840
You came to the right place.

60
00:05:17,390 --> 00:05:24,860
An IPV six packet is the smallest message entity exchanged via the internet protocol across an IPV six

61
00:05:24,860 --> 00:05:25,640
network.

62
00:05:25,820 --> 00:05:27,230
But stay with me here.

63
00:05:27,260 --> 00:05:34,160
The packets consist of control information for addressing and routing and a payload consisting of user

64
00:05:34,160 --> 00:05:34,700
data.

65
00:05:35,240 --> 00:05:43,190
The control information in IPv6 packets is subdivided in a mandatory fixed header and optional extension

66
00:05:43,190 --> 00:05:43,880
headers.

67
00:05:44,460 --> 00:05:52,410
The fixed header starts an IPV six packet and has a size of 40 octets, which means 320 bits.

68
00:05:52,680 --> 00:05:55,080
Its format is shown in the slide.

69
00:05:56,120 --> 00:05:58,130
Version is constant.

70
00:05:58,130 --> 00:05:59,030
Six.

71
00:05:59,210 --> 00:06:05,600
Payload length is the size of the payload in bytes, including any extension headers.

72
00:06:05,840 --> 00:06:10,700
Hop limit replaces the time to live field in the IPV four.

73
00:06:11,210 --> 00:06:16,010
Well, I think source address and destination address fields are fairly obvious.

74
00:06:17,230 --> 00:06:24,100
Extension headers carry optional internet layer information and are placed between the fixed header

75
00:06:24,100 --> 00:06:26,560
and the upper layer protocol header.

76
00:06:27,670 --> 00:06:29,230
128 bit.

77
00:06:29,260 --> 00:06:34,480
IPV six addresses are written using hexadecimal as opposed to dotted decimal.

78
00:06:34,510 --> 00:06:35,920
Back in IPV four.

79
00:06:36,470 --> 00:06:39,710
Because a hexadecimal number uses four bits.

80
00:06:39,740 --> 00:06:45,080
This means that an IPV six address consists of 32 hexadecimal numbers.

81
00:06:45,770 --> 00:06:50,000
These numbers are grouped in fours, giving eight groups or blocks.

82
00:06:50,180 --> 00:06:53,960
The groups are written with a colon as a separator.

83
00:06:55,010 --> 00:06:58,040
An IPV six address example is shown in the slide.

84
00:06:59,240 --> 00:07:05,150
So because of the length of the IPV six addresses, various shortening techniques are employed.

85
00:07:05,330 --> 00:07:10,820
The main technique being to omit repetitive zeros as shown in the example.

86
00:07:12,260 --> 00:07:17,360
So as I mentioned before, in IPV four, an address is split into two components.

87
00:07:17,360 --> 00:07:17,930
Right?

88
00:07:18,050 --> 00:07:19,850
Network ID and a host ID.

89
00:07:20,450 --> 00:07:26,030
This was done initially using address classes and then later using subnet masking.

90
00:07:26,970 --> 00:07:29,550
In the unicast addressing of IPV six.

91
00:07:29,580 --> 00:07:31,320
It's done in the same way.

92
00:07:31,970 --> 00:07:35,030
The first step is to split the address into two parts.

93
00:07:35,450 --> 00:07:38,660
The address is split into 264 bit segments.

94
00:07:39,790 --> 00:07:45,280
The top 64 bits is a network ID and the lower 64 bits is the host ID.

95
00:07:46,680 --> 00:07:51,960
The most significant 64 bits are used for routing and the least significant 64 bits.

96
00:07:51,960 --> 00:07:55,260
Identify the address of the interface or host.

97
00:07:55,620 --> 00:08:00,000
This block is derived from the actual physical or Mac address.

98
00:08:00,030 --> 00:08:01,110
In practice.

99
00:08:02,430 --> 00:08:09,780
So if we look at the most significant 64 bits in more detail, we can see that it's split into two blocks

100
00:08:09,780 --> 00:08:12,630
of 48 and 16 bits.

101
00:08:13,460 --> 00:08:20,030
Now the least significant 16 bits are used for subnets on internal networks and are controlled by a

102
00:08:20,030 --> 00:08:21,530
network administrator.

103
00:08:22,630 --> 00:08:28,750
The most significant 48 bits are used for the global network addresses and are used for routing over

104
00:08:28,750 --> 00:08:29,410
the Internet.

