Some votes about can figure in the console the default form that is used by the console application
can make it difficult to differentiate between important characters and not so important when you use
Windows power shell.
So it is usually a good idea to configure a different font.
You may also want to change the font size and colorist to make the text easier to read when you open
the shell type the following characters and make sure that you can easily differentiate between them.
These characters are important so you have to remember them grief X and single quotation mark open parenthesis
open curly brace open square or break it open and go bracket to or greater than symbol.
If any of these characters seem too similar to one another try configuring the console to use a different
font through type formats in particular maybe easier to read than the default raster of want to configure
a new font.
Click the control box in the upper left corner of the console window from the shortcut manual select
Properties and then select the font.
You can also select a font size on this tab.
You should also size the shell window to fit completely on your screen so that no command output will
be positioned of screen.
In addition configure the console window not to have a horizontal scroll bar to do this.
Open the console property dialog box again and then select the Lillet lay out to make sure that both
the screen buffer size and window size have the name value that is shown of widths.
It is fine for the hate to be significantly larger for the screen buffer size.
Close the dialog box and verify that the window fits on the screen and that no horizontal scroll bar
is shown a vertical scroll bar will still be present in this console.
Finally if you are dissatisfied with the default white and blue color scheme the console's properties
dialog box will ask you to select from a smaller range of a tentative color.
Use the color of step to do this.
Noting that you can change only the primary text color the color of error messages and the output cannot
be changed from this dialog box.
Remember that the console host doesn't support clipboard copying and pasting.
Also it doesn't use standard keyboard shortcut.
Use the mouse pointer to highlight a block of text and press enter to copy that text physically board.
Right click the mouse button to paste for this copy and paste functionality to work.
You need to ensure that Greek edit mode is unable to in the console's properties dialog box on the options
tab that is and the added options section.
This mode may be enabled by default.