[&] Which of the following accurately describes the differences between 802.3af, 802.3at and Cisco UPoE? (Select the best answer)
- All of these answers are correct
- None of these answers are correct
- IEEE 802.3af utilizes 8 wires within twisted-pair cabling to deliver power.
- Cisco UPoE utilizes 8 wires within twisted-pair cabling to deliver power. -- Correct
- IEEE 802.3at utilizes 6 wires within twisted-pair cabling to deliver power.

[&] Using PoE terminology, which of the following acronyms would be appropriate to describe a LAN Switch that supplies power to several IP Phones? (Select the best answer)
- The LAN Switch is an example of PE
- The LAN Switch is an example of a PD
- The LAN Switch is an example of a PSD
- The LAN Switch is an example of PSE -- Correct

[&] With regards to IEEE standards governing PoE, which type of PD requires the greatest amount of power to function? (Select the best answer)
- Type-3 device
- Type-4 device -- Correct
- Type-2 device
- Type-1 device
- Type-5 device
- Type-4b device

[&] At present, which types of devices are NOT typically powered using PoE? (Select the best answer)
- Laptops -- Correct
- IP Phones
- Wireless Video Cameras
- Wireless Access Points

[&] Which of the following are true with regards to PoE detection? (Select the best answer)
- PSEs will output a small amount of voltage to detect if there is any corresponding resistance from potential PDs. -- Correct
- PDs will output a small amount of voltage to detect if there is any corresponding resistance from potential PSEs.
- PSEs will, upon initial connection, loopback wires two(2) and four(4) to the PD.
- PDs will, upon initial connection, loopback wires two(2) and three(3) to the PSE.