[&] Which of the answers below list the correct way (and in the correct order) to perform a password-recovery mechanism on a typical Cisco router? (**Select the correct answer**)
- 1. Reload the device by entering the "reload" command.
2. Repeatedly press the escape sequence while the device is booting until you see it has gone into the ROMMON state.
3. Change the configuration register setting so that the device will not load the Startup-Configuration file.
4. Type the "reset" or "i", or "boot" commands to reset the device.
5. Ignore the Initial System Configuration Dialogue
6. Go into Privileged EXEC and load the Startup-Config back into the Running-Config

- 1. Perform a hard reboot on the device by depressing the power button.
2. Turn the device back on.
3. Ignore the Initial System Configuration Dialogue
4. Go into Privileged EXEC and load the Startup-Config back into the Running-Config
5. Change the enable password.
6. Change the configuration register setting to 0x2102.
- 1. Perform a hard reboot on the device by depressing the power button.
2. Turn the device back on.
3. Repeatedly press the escape sequence while the device is booting until you see it has gone into the ROMMON state.
4. Change the configuration register setting to 0x2142.
5. Type the "reset" or "i", or "boot" commands to reset the device.
6. Ignore the Initial System Configuration Dialogue
7. Go into Privileged EXEC and load the Startup-Config back into the Running-Config
8. Change the enable password.
- 1. Perform a hard reboot on the device by depressing the power button.
2. Turn the device back on.
3. Repeatedly press the escape sequence while the device is booting until you see it has gone into the ROMMON state.
4. Change the configuration register setting to 0x2102.
5. Type the "reset" or "i", or "boot" commands to reset the device.
6. Ignore the Initial System Configuration Dialogue
7. Go into Privileged EXEC and load the Startup-Config back into the Running-Config
8. Change the enable password.

[&] What is the main objective of performing a Cisco IOS password-recovery procedure? (Select the best answer)
- To display the forgotten password
- None of these s are 
- Both of these s are 
- To force the device to bootup and bypass the Startup-Configuration file.

[&] Once you have entered ROMMON mode, which setting for the IOS Configuration-Register would be appropriate to inform the IOS device to bypass the Startup-Configuration file and boot as if this file didn't even exist? (Select the best answer)
- 0x2402
- 0x2104
- 0x2142
- 0x2122

[&] Which of the following statements are true with regards to performing password-recovery on a Cisco IOS device? (Select the best answer)
- You must have access to the console port of the device.
- You can perform this action over a Telnet connection
- You can perform this action as long as you have access to any interface on the box
- You can perform this action over an SSH connection