[&] Dynamic ARP Inspection needs to be enabled on VLAN-132. The DHCP Server is reachable via interface Gigabit0/1 on this VLAN and the Default-Gateway is reachable via Gigabit0/2 on this same VLAN. Which of the following commands must be configured to get Dynamic ARP Inspection operational? (Select the correct answers)
- Switch(config)#interface Gigabit0/1
Switch(config-if)#ip arp inspectiontrust
- Switch(config)#ip arp inspection enable
- Switch(config)#ip arp inspection vlan 132
- Switch(config)#interface Gigabit0/2
Switch(config-if)#ip arp inspection trust
- Switch(config)#vlan 132
Switch(config-vlan)#ip arp inspection
- Switch(config)#ip arp inspection

[&] Under what circumstances would it make sense to create an ARP Access-List to pair up with Dynamic ARP Inspection? (Select the best answer)
- When you wish to implement Port-Security
- When most of your devices utilize DHCP-derived addresses
- When you don't wish to utilize DHCP Snooping
- When you have a desire for job security

[&] Which of the following answers represents a piece of data that is NOT displayed in the output of the command "show ip arp inspection"? (Select the best answer)
- The VLANs associated with Dynamic ARP Inspection
- ARP Access-Lists that have been associated to Dynamic ARP Inspection
- The "trust" state of individual interfaces
- The number of ARPs that have been dropped by Dynamic ARP Inspection