description

Helpful Hints about INE’s virtual lab environment:

Lab Notes:

  1. On all IOS devices (routers and switches) load the preconfiguration file from flash: memory titled, “Lab-3-Begin”.

  2. Once you perform the step above the following will be preconfigured for you:

If you get stuck at any point during this lab and wish to view the Lab Solution, load the pre-configuration file (on any IOS device) named, “Lab-3-Solution” from flash memory.

Solution

Lab solutions are stored as viewable (and loadable) named configuration files stored in Flash memory on each device. To view the Lab Solution, login to any IOS device in your topology (Routers or Switches) and issue the following command:



    Router>enable
    Router#more flash:Lab-3-Solution
    !
    version 15.9
    service timestamps debug datetime msec
    service timestamps log datetime msec
    no service password-encryption
    !
    hostname R1
    !
    boot-start-marker
    [SNIP]

To Load** the solution configuration onto your device follow the procedure below. Please NOTE that **this procedure will completely erase your current configuration file and overwrite it with the solution configuration file:



    Router-1#configure replace flash:Lab-3-Solution
    This will apply all necessary additions and deletions
    to replace the current running configuration with the
    contents of the specified configuration file, which is
    assumed to be a complete configuration, not a partial
    configuration. Enter Y if you are sure you want to proceed. ? [no]: yes

    *Jul 29 19:10:01.921: Rollback:Acquired Configuration lock.
     WARNING: Command has been added to the configuration using a type 0 password. However, type 0 passwords will soon be deprecated. Migrate to a supported password type

    *Jul 29 19:10:04.061: %AAAA-4-CLI_DEPRECATED: WARNING: Command has been added to the configuration using a type 0 password. However, type 0 passwords will soon be deprecated. Migrate to a supported password type

    *Jul 29 19:10:05.067: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up
    Total number of passes: 1
    Rollback Done

    R1#

Footer